Aluminum-clad windows and doors
Windows or doors of wood construction covered on the exterior with extruded (Eagle windows) or roll-formed aluminum. Has a factory-applied finish to deter the elements. The extruded aluminum adds structural capabilities to the product and helps eliminate warping and damage through handling.
Non-tempered glass. Tends to break into jagged shards, as opposed to small pebbles.
Inside horizontal trim located under the window stool at the bottom of a unit.
An odorless, colorless, tasteless, nontoxic gas that is six times denser than air. Replacing the air between two panes of glass with argon gas reduces temperature transfer, making the surface of the glass inside the house closer to the inside temperature.
The center member of a double door, which is attached to the fixed or inactive door panel.
Auxiliary frame window
Eagle’s version of a fixed, direct set window frame where glass is set directly into a frame without a sash. Is used in the creation of geometric and radius windows.
Hinged at the top, this window has a single sash that swings outward from the bottom.
Device for counterbalancing a sliding sash, usually associated with a double-hung window, so sash may be held open at any given position. Usually a system of cords, weights, springs, spiral devices or block and tackle hardware.
A composite of 3 or more windows that project out from the wall. Usually consists of one large center window with two flanking fixed or operating windows at 30, 45, or 90 degree angles to the wall.
Bottom horizontal member of a window sash.
A composite of 3 or more windows in a radial or bow formation. Typically consists of casement windows both fixed and operating assembled at 10 degree angles from the wall.
Standard outside casing around the window to cover the gap between the window frame and the opening. Nails are driven through the molding to install the window to the framed opening.
Lead strips which bond small pieces of decorative glass in windows.
A window with side hinges that cranks outward from either the right or left.
A hardware device used to operate a casement window to any open position.
Molding or trim available in many widths, thicknesses and profiles applied to the frame around a window or door to cover the space between the window frame and wall.
On a double-hung window, the bottom rail of the upper sash and the upper rail of the lower sash, where the lock is mounted.
A generic term referring to a variety of window units with one or more curved frame members, often used over another window or door.
Usually an aluminum or vinyl material fixed to the outside faces of wood windows and doors to provide a durable, low-maintenance surface.
Classic Divided Lights
Eagle’s version of simulated divided lights without the spacer bars between the glass. This economical option features fixed exterior bars and removable interior wood grilles for easy cleaning from the inside.
A venting or fixed window in the upper part of a lofty room that admits light to the center of a room.
The deposit of water vapor from the air on any cold surface whose temperature is below the dew point, such as a window glass or frame that is exposed to cold outdoor air. Is controlled by limiting the amount of humidity inside of a room relative to the outdoor temperature.
Cottage double-hung window
A double-hung window in which the upper sash is shorter than the lower sash.
A handle that attaches to an awning or casement operator, used to open the venting window.
A space which projects from the roof of a house, usually including one or more windows.
A window with two vertically moving sashes, each closing a different part of the window.
Horizontal exterior molding to divert water from the top casing so water drips beyond the outside of the frame.
A board used to increase the depth of the jambs of a window frame to fit a wall of any given thickness.
A form produced by forcing metal or vinyl through a die. Window and door frames are often clad with extrusions.
The arrangement, proportioning and design of windows and doors in a building.
A wood end-joint formed by a set of interlocking fingers, coated with adhesive and meshed together under pressure.
Fixed light (also fixed sash)
Window or sash which is non-operative or non-venting.
An enclosure or combination of parts which surround a window sash or door panel.
French sliding doors
A sliding door which has wider panel members around the glass, thus giving it the appearance of a hinged French door.
Full Window or Door Replacement
Replacing the entire window or door structure, including the frame.
A fixed framed window made up of 2 or more angles (i.e., pentagon or trapezoid).
The glass panes or lights in the sash of a window. Also the installation of glass in a window.
Glazing bead (also glass stop)
Removable trim that holds glass in place.
Grille (or muntin bar)
Usually removable for easy cleaning, grilles give the appearance of a divided window pane.
Head jamb (also head)
All of the horizontal members that make up the top of the window or door frame.
Supporting member or beam above window opening which transfers building weight above to the supporting wall structure on each side of the window.
Hinged French doors
Hinged door(s) which have wider panel members around the glass.
Impact resistant glazing
Glass specifically manufactured to withstand impacts from airborne objects or forced entry. Usually a type of laminated glass often used in coastal areas impacted by hurricanes.
A combination of 2 or more panes of glass with a hermetically sealed air space between the panes. The space may be filled with an inert glass such as argon.
The vertical members at the side of the window or door frame.
Width of the window frame from inside to outside.
The plastic or metal track installed in the jambs of the window in which the window sash slide.
The hook-shaped piece of hardware that it is mounted on the inside sash stile of a casement window in which the sash lock engages.
Similar to the construction of car windshields, this technique sandwiches a piece of transparent film or plastic between two panes of glass. Typically used for safety reasons because of its resistance to shattering. Also reduce noise transmission to the interior.
A handle or grip installed on the bottom sash rail of a double-hung window to assist in the raising or lowering of the sash.
Light (also lite)
A window; a pane of glass within a window. Double-hung windows are designated by the number of lights in the upper and lower sash, as in 6-over-6.
A term used to refer to glass which has low-emissivity due to a film or metallic coating on the surface of the glass. Usually constructed of dual, sealed panes of coated glass filled with pure inert gas to block ultraviolet heat, for cooling purposes, while reflecting room heat back into the room for heating purposes.
Laminated Veneer Lumber – A combination of many pieces of veneered lumber glued together to give added structural capabilities. Often used in window or door frames.
The space in a masonry wall left open for the window or door.
Meeting rail (also lock rail)
One of the two horizontal members of a double-hung sash which come together. A check rail.
The vertical member in a pair of stiles, as in abutting casement windows.
A slot or rectangular cavity cut into a piece of wood to receive another part.
Mortise and tenon
A strong wood joint made by fitting together a mortise in one board and a matching projecting member (tenon) in the other.
A vertical member (usually wood or metal) to structurally join two window or door units.
Vertical or horizontal bars used to separate glass in a sash into multiple lights. Often called a grille.
A vinyl or aluminum extension attached to the frame of a window or door which creates a positive seal between the window and the framed wall. Acts as an additional barrier against air and water leakage. Screws or nails are fastened through the fin to hold the unit in the opening.
Window which can be opened for ventilation.
A metal arm and gear attached to a window which allows for easy operation.
A large, arch-top window flanked by smaller windows on each side.
Usually refers to the glazed panel or panels in a door frame.
A vertical strip on each jamb that separates the sash of a double-hung window.
Large fixed windows.
The measurement of resistance to heat transfer in a material. The higher the R-Value, the greater the insulation value.
Horizontal member of a window sash or door panel.
The act of replacing only the glass in a window or door.
A framed opening in which the unit will be installed.
Framework of stiles and rails in which the glass of a window or door is set.
A lock applied to the window to pull the sash tightly against the frame (casement) or to pull the check rails together (double-hung) in order to seal the sash from weather and for security.
A flat board cut to fit the contour of a bow or bay window and installed between the sill and the wall surface, providing a seat or a shelf space for plants, etc.
Decimal value which is the solar gain of a window, divided by the solar gain for a clear single-glass window of the same size. The shading coefficient of clear, double-glazing is about 0.85 to 0.9.
A fixed, often narrow glass window next to a door opening or window opening.
Horizontal member at the bottom of the window frame.
Simulated divided lights
A method in constructing windows or doors in which muntins are fixed to the inside and outside of the insulated glass panel to simulate the look of a true divided light. Modern Divided Light® in Eagle terminology.
Use of single panes of glass in a window sash or door panel. Not as efficient as double glazing.
Window similar to double-hung window, except the top sash is stationary.
Windows which slide horizontally.
Combined grouping of awning, casement, or non-operative windows to form a large glazed unit.
Vertical member of a window sash or door panel.
Stile Lug or Horn
One of two extensions of the sash stiles to support the upper sash of a double-hung window.
An interior trim on a window which extends the sill and acts as a narrow shelf. Often seen on double-hung window.
A wood trim member nailed to a window frame to hold, position or separate window parts.
A locking system which secures the window at two locking points by the operation of one lever.
Special heat-treated, high-strength safety glass which shatters into pebble-sized particles and not in slivers.
A rectangular projection cut out of a piece of wood for insertion into a mortise.
A thermal insulating barrier between two thermally conductive materials.
Small window located above a door or another window.
Horizontal member separating a door from a window panel above the door, or separating one window above another.
Three panes of glass with two air spaces between, commonly consisting of an insulating glass with a separate storm sash. Also available in an insulating window in a single frame.
Measurement of heat transfer through a given material. The lower the U-Value, the better the insulation value.
A window or door that operates or opens for ventilation.
A strip of resilient material applied to the perimeter of the sash and/or frame of a window or door to minimize the potential for water and air infiltration.
The force exerted on a surface by moving air.